Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by Ccancro

  1. Ccancro

    St52-3 DIN

    unclesyd thanks for your reply the site was very helpful Charles J. Cancro WWW.limehousesons.com
  2. Ccancro

    St52-3 DIN

    Thanks for all your help. Charles J. Cancro WWW.limehousesons.com
  3. Ccancro

    St52-3 DIN

    I was just trying to find out if 516 grade 70 is a safe substitute for St52-3. And if there is pre and post heating required for welding. Charles J. Cancro WWW.limehousesons.com
  4. Ccancro

    St52-3 DIN

    I am trying to find a compatable material for St52-3. I am coning up with A572 grade 60 but that is not supplied either. My only other shot at this is 516 grade 70. This material is going to be fabricated into a built up tension member for a clam shell bucket. I am just curious if anyone has any...
  5. Ccancro

    Line angle compression on spreader bar

    I am trying to calculate the line angle compression on an adjustable spreader bar. I am running into some trouble with the calculations for the% of load applied to the center of the bar through line angle to figure out what type of buckling I am going to run into. Any help would be great...
See more

Part and Inventory Search

Back
Top Bottom