Hi Greg - I've done all the math (I think) but i still don't see how am i may going to graph it. Please help
See attached file.
Thanks a lot.
Thomas http://files.engineering.com/getfile.aspx?folder=91ab00ec-41c0-4be3-a1f1-b3f8c7c2fddb&file=Wheel_runout.xls
Wow! I've been working at this wheel company for x number of years and we've never done a correlation yet; although, we correlated our stress values and distribution vs. actual performance test by just comparing FEA results to pass no-pass performance lab reports. I’m sure we will pull out the...
Thank you guys!
Here is my problem, I'm working on a wheel that will be fitted with a presure sensor on the drop-well area, and after the part is fitted with it the balance goes up. So, I'm thinking about a counter-weight at specififed radius.
With the explanation you guys have given me, now...
Hi Greg -did that. but the amount was too large.
e.g.
mass of the part 18.4 kg
C.G. X=57.93mm
Y= 0.227mm
Z=-0.019mm
Geometrical axis is "x", which is going thru the pilot bore.
Radius of C.G.=0.228
Static unblance= 4.19kg-mm
Is this correct?
Now, I want correlate this with a...
