Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by Carlos337
-
Measuring System Improvement
Hello IRstuff. Thanks for your reply. A little bit of background may help. I am trying to measure the distance between parts 3D printed on a platform. The nominal value is 135mm and I am using Mitutoyo calipers. I want to know if the spacing is consistent across the build area on both X and Y...- Carlos337
- Post #3
- Forum: QC, Inspection & Testing engineering
-
Measuring System Improvement
Hi all, Can I improve the performance of my measuring system by increasing the number of measurements taken for any given part? I ran a Gage R&R with 3 operators, 10 parts and 10 replicates. The %Tolerance was 43%, so pretty crap... However, it seems to me that if I take more than one...- Carlos337
- Thread
- Replies: 6
- Forum: QC, Inspection & Testing engineering
