Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by CanosSon
-
Correct tolerance call out for extruded Aluminum bar
Hello all, I have an extruded bar of Aluminum 6061, with a small inner design but mostly solid. The profile is 0.90" x 6" and it is 60" long, lets call this piece the stock. I need to machine the stock down to 0.875" +/- .01, by removing material evenly both top and bottom. However, the twist...- CanosSon
- Thread
- Replies: 1
- Forum: Drafting Standards, GD&T & Tolerance Analysis
