Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by Camo5
-
Datums help on a simple sheetmetal part
Hi all, I've started working towards learning my way through the ASME GD&T standards but still having a hard time wrapping my head around setting up my datums. I've got this part that welds to a U shaped tube that goes through both 1/2" holes in the middle, and the large radial cut from the top...- Camo5
- Thread
- Replies: 0
- Forum: Drafting Standards, GD&T & Tolerance Analysis
