Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by Cajun62234

  1. Cajun62234

    Junction Box Design (NEC 314.71)

    Thanks...your reply is exactly what I finally concluded after beating the NEC to death to find an answer... Thanks again.
  2. Cajun62234

    Single Phase Transformer Standards

    Why am I thinking this is a 'buck 'n boost' situation....maybe I'm not digesting the problem?
  3. Cajun62234

    Junction Box Design (NEC 314.71)

    Junction box sizing clarification. Here's my dilemma: Extending 2 sets of 3#350kcil, 1#1G, 3½"C. via Junction Box (and compression fittings); straight through, no bends. Handbook NEC 314.28(A)(1) states that 314.28(A)(2) applies if splicing in a straight pull; thus allowing 6x91mm (3½" = 91mm...
See more

Part and Inventory Search

Back
Top Bottom