Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by cadbrowser

  1. cadbrowser

    Tolerance for Pipe Schedule per ASME B36.10

    NozzleTwister said: "There is no default accuracy of +/- .010 because of the 3 decimal place designation." You need to re-read my statement which was: Our drawing indicated that we needed a .957 I.D. (by default if we indicate a 3 place decimal there is a tolerance of +/- .010). The default...
  2. cadbrowser

    Tolerance for Pipe Schedule per ASME B36.10

    We had some 1" piping come in (X-Strong or Schedule 80) that measured O.D. = 1.315 I.D. = .980 Our drawing indicated that we needed a .957 I.D. (by default if we indicate a 3 place decimal there is a tolerance of +/- .010). According to some literature referencing ASME B36.10 the allowable...
See more

Part and Inventory Search

Back
Top Bottom