Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by byronm

  1. byronm

    Replacing flange studs under pressure

    Thanks MJCronin. I had found some of these references but not all of them.
  2. byronm

    Replacing flange studs under pressure

    Some of the nuts are not "fully" engaged and some have moderate corrosion. Most are in ANSI 150,300 or 600 with B7 studs. This is natural gas service.
  3. byronm

    Replacing flange studs under pressure

    I will post this under ANSI standards as well. Thanks
  4. byronm

    Replacing flange studs under pressure

    We have been asked to make a standard to replace flange studs while the line is still loaded. I am a little leary about this. Do any of you have a guideline established that you can share?
See more

Part and Inventory Search

Back
Top Bottom