Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by Bvan
-
idw dimension problem
Ok, I have figured out part of my problem. This problem is because the dimension is not actually an even dimension such as a 6'-0" dimension is actually 72.0001" and so the idw file dimension shows 6'-" letting me know that there is more there then just 72". I know the easy solution would be to...- Bvan
- Post #2
- Forum: Autodesk: Inventor
-
idw dimension problem
When creating a dimension that shows an even foot length such as 6'-0", Inventor insists on showing only 6'-" without the 0. I constantly get questioned on this from our fabrication shop and need to figure out a way to correct this. Can anyone help??? Thanks, Bvan- Bvan
- Thread
- Replies: 1
- Forum: Autodesk: Inventor
