Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by bushben
-
Igus Iglide J experience with 440C shafting
I am currently using an Igus Iglide J bushing (jsm-0810-08) in a rotary application (speeds of 135 ft/min) with an 8mm (h5) 440c shaft. We have recently discovered that the shaft is not as rough as we thought, and I suspect this is leading to varying degrees of stick slip, squeaks, and...- bushben
- Thread
- Replies: 0
- Forum: Bearing design, manufacture and maintenance
