Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by bukac1

  1. bukac1

    Effect of exhaust tube thickness on vibration

    Try just recently published book by Prof. Wermer Soedel of Purdue University. The name of book consist word Shell(s). Sorry I don't know more details.
  2. bukac1

    psychoacoustics

    Try this book: Noise and Vibration Control, edited by Leo L. Beranek
  3. bukac1

    white noise

    Just recently, Congress enacted a law that mandates all new electronic communication devices must allow government agents free access to monitor the communication. Any attempt to interfere with it or to block government agents from monitoring your communication will put you in jail!
  4. bukac1

    Experience with O-Matrix

    Try www.bluebit.gr it has everything one may need and it costs less than $200.00
  5. bukac1

    high compressor discharge

    Check temperature on the discharge pipe close to the compressor. Then consult tables of the properties of the refrigerant the compressor works with. If the table shows the condensing (saturated vapor)pressure is the same or close to the pressure you measured, then problem is high consensing...
  6. bukac1

    four pole noise analysis?

    To explain application of direct solution of the wave equation in the design of mufflers requires solid knowledge of mathematics (partial differential equations, matrix algebra, solution of systems of equations in complex numbers,and programming. I am sorry for you. You are, or your boss is...
  7. bukac1

    four pole noise analysis?

    Best source of info is: M.L Munjal,Acoustics of Ducts and Mufflers, John Willey & Sons, 19897. However, the Four-pole method is an obsolete stuff. A method based on solution of the wave equation is much better. I will be presenting a paper on this method at this year's 18th International...
  8. bukac1

    Balancing Program PC Based

    There are two ways to balance a rotating machine. The first one is the numerical balancing based on drawings.The second one is in-situ or experimental balancing of a manufactured machine. Which one do you have on your mind?
  9. bukac1

    Duct sizing calculations

    Try "Energy Plus", you can find it on Google. Its free!
  10. bukac1

    pressure in the system

    It seems to me that you may have either not enough refrigerant in the system or system contaminated with air. A non-working system with correct charge shouldh read (at 70F ambient temperature) 9.38 bar. Under-charged system will read less. A working system has pressures at evaporator and...
  11. bukac1

    Can elasto-plastic stiffness matrix be unsymmetric?

    Generaly yes. Elastoplastic problems are generaly non-linear, especially whwn hysteresis is considered.

Part and Inventory Search