Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations KootK on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by buchner

  1. buchner

    Can I relate a hole pattern to be parallel and/or perpendicular only?

    Dear Kenat, thanks for replying. I think that the composite will only tighten within the pattern but will not locate the pattern any better for the angle. Maybe if I only composite true position 2.0 | B | A | C | true position 0.1 | B | A | ? Then I am making one side tight - that...
  2. buchner

    Can I relate a hole pattern to be parallel and/or perpendicular only?

    Hi, I have a part where I only care if the reamed hole pattern is aligned with the datums. That is, the rows and columns of the pattern are parallel and perpendicular to 2 datums (A and C). I want these to be within +/- 0.05 mm range to allow for a small angle in relating the parts. The...
See more

Part and Inventory Search

Back
Top Bottom