Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by bSnacks10
-
Dimension Question
For this plain mounting pate I would dimension from the outside(s) (as shown). Then there are 4 cutouts at the corners. Regarding that 0 horiz. dim at the bottom, I wasn't sure how the industry views having the 0,0 at "a" and then having to show positive dim's in both the up and down. Hopefully...- bSnacks10
- Post #3
- Forum: Drafting Standards, GD&T & Tolerance Analysis
-
Dimension Question
Our company uses ordinate dimensioning. We have standards established but when new guys come in there's usually discussions as to what was taught in school etc. Question: 1. How do you approach the 0,0 position, should it be of the same edge "a" or how its shown? a. How would the fabricator...- bSnacks10
- Thread
- Replies: 8
- Forum: Drafting Standards, GD&T & Tolerance Analysis
