Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by brunsqm
-
Designing a Gage to check GD&T
I thought that would be the case. What about locating the Y,Z datum simulators? Are they located nominally or do they take into account that the outer profile of the part has a profile tolerance? What is they best way to check the profile tolerance? A Go gage using expanding mandrels for...- brunsqm
- Post #3
- Forum: Drafting Standards, GD&T & Tolerance Analysis
-
Designing a Gage to check GD&T
I am trying to design a functional gage or gages that will check the position tolerance and the profile tolerance relative to A,B,C on this drawing. Couple questions: Can I have one gage to cover both requirements? Are my datum simulators for X,Y,Z located based on the...- brunsqm
- Thread
- Replies: 3
- Forum: Drafting Standards, GD&T & Tolerance Analysis
