Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by BrotherJohn

  1. BrotherJohn

    PM: Sponge iron vs. Atomized powder

    Hi All, I am trying to evaluate the difference between Sponge iron and atomized powders. The MPIF Standard 35 for F-0000-10 shows a hardness of 40 HRF and a Fatigue Limit 90% Survival of 46 MPa @ a density of 6.1 g/cc. These numbers are in line with with our measurements for Sponge iron...
  2. BrotherJohn

    PM: Sponge iron vs Atomized powders

    Hi All, I am trying to evaluate the difference between Sponge iron and atomized powders. The MPIF Standard 35 for F-0000-10 shows a hardness of 40 HRF and a Fatigue Limit 90% Survival of 46 MPa @ a density of 6.1 g/cc. These numbers are in line with with our measurements for Sponge iron...
  3. BrotherJohn

    Linear sliding bearing material

    Thanks for taking the time to respond. Brother John
  4. BrotherJohn

    Linear sliding bearing material

    Hi all, I am looking for a plastic material for linear sliding bearing application that will see high PVs, need a low co-efficient of friction, see a max service temp of about 325 F and see oil mist constantly. Thanks in advance, Brother John
See more

Part and Inventory Search

Back
Top