i know that rick kippley made a head for a pulling tractor out of aluminum and it worked very well. if your into pulling i'm guessing that you might know who rick kippley is. i don't see any reason that you can't do it.
so is it more because of the taper in the plenum? i have been reading a lot on the forums because I'm making a manifold for my car too. i don't want any issues with one cylinder getting fed more then another. the manifold will be equal length runners so all i really need it plenum size and...
i would also like to know if the pressure difference is caused by the taper in the manifold or if that is helping it? it looks, to me, like taper is causing more pressure difference. would internal velocity stacks make a difference in the flow in that manifold, making it more even? if you...
thanks i guess that 1/2 engine volume is a good place to start. i found some other info that said that but it was talking on a non turbocharged engine. here is what i found on grapeaperacing.com
"Plenum Volume
There is not going to be a simple answer to
the needed plenum volume for a given...
is there some type of help that someone can give? a site that might have some more info for me to read. a basic rule of thumb that says plenum volume shold be the same as engine volum, anything?
Hello I found this site a long time ago and have been reading everything that I can find that has to do with what I’m about to ask, so please don't tell me to use the search button.
What I have is a 2.4 liter turbo charged engine and what I would like to know is what the required plenum...
