Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by briarpatchbluehen

  1. briarpatchbluehen

    220vac 1p to 110vac 1p

    My "special need" is to provide power to a mini ROV that requires to be plugged into a 110vac, 1P, 30 amp receptacle (similar to an RV). I have a 220 amp, 1p 30 receptacle and was hoping to use that but I have an issue with the wires (which ones to use? if at all).
  2. briarpatchbluehen

    220vac 1p to 110vac 1p

    I have a 30 amp 220vac service receptacle (wired for a dryer but never used). I have a special need for a 30 amp, 110vac connection and would like to tie into this receptacle somehow. There are three wires connected to this receptacle: Black, Red and Green (all insulated). I checked voltages...
  3. briarpatchbluehen

    Padeye design with a bronze bushing

    Thanks for the tip. Really got me off center. Take care.
  4. briarpatchbluehen

    Padeye design with a bronze bushing

    I am designing a steel padeye with a bronze bushing for the first time. The bushing is 1 3/8" O.D. for a 1" steel pin. This is for a U boom, so there will not be a lot of rotation. I was looking at an SAE 660 bronze bushing, but the min. specified yield strength is 20ksi. Can anyone suggest...
See more

Part and Inventory Search

Back
Top Bottom