Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations KootK on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by BradfordJim

  1. BradfordJim

    Machining Bearing Holder

    If you only have to make a few, just bite the bullet and machine them. With a CNC it is not a big deal. However the 4-40 threaded holes are a pia. If anything the tapping will be a problem with potential breakage of taps. Use a bigger thread if possible, 10-32 would make it much easier...
See more

Part and Inventory Search

Back
Top Bottom