Agreed powerhound, however the debate I was concerned with was whether or not the print + solid model could control the thickness of the part. And if so, to what extent.
Correct, no thickness callout, no datum reference on the profile of a surface callouts. Inspector says solid model controls thickness using .010" surface as a datum. I didn't think that was the case so I wanted popular opinion on the subject.
Good morning everyone. I was wondering how you could interpret this situation:
A box with a profile of a surface of .010" on the top surface, and a second profile of a surface callout of .020" on the bottom surface.
What controls the thickness? And what would the tolerance be?
Thank you in...
