Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by bpreeves
-
NX9 Routing Electrical spline path and slack performance.
This appears to be related to adding slack. Without slack the converted NX9 spline is quickly editable, but when selected and the slack option is chosen it takes 15-60 minutes to add slack. Short branches <15 points perform better. This worked fine in NX 8.5 on any length cable. Slack and the...- bpreeves
- Post #4
- Forum: Siemens: UG/NX
-
NX9 Routing Electrical spline path and slack performance.
Thanks for looking at this. I have a PR with GTAC.- bpreeves
- Post #3
- Forum: Siemens: UG/NX
-
NX9 Routing Electrical spline path and slack performance.
Converting NX 8.5.3 cable spline paths with slack to NX 9.0.2 splines is extremely slow. After conversion, editing the spline is nearly impossible. Each edit is taking 15-30 minutes to complete on long cables. Removing slack in 8.5 then converting the splines in 9.0 is a workaround, but adding...- bpreeves
- Thread
- Replies: 3
- Forum: Siemens: UG/NX
