Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by bowen44

  1. bowen44

    5 Volt Regulator Card

    Sorry I was trying to be brief. Here is more detail to the question: The 5V regulator card is used in a Tempest Isolation Filter (TIF). The TIF is installed on the interface lines to prevent inadvertent transmission of classified data. It receives 5 and 15 VDC operating power from another...
  2. bowen44

    5 Volt Regulator Card

    What would be the significance of testing a 5 Volt Regulator Card by taking the difference of two current measurements. One measurement at 15V and the other at 14V. The voltage regulator is used to drive LS32 and LS13 Line Drivers and Receivers. Thanks
  3. bowen44

    Battery Tab Connections

    I am in a bit if a dilemma trying to figure out what would be a better way to connect the leads to the tabs of a batter pack. The battery pack is 8 Hawker D-Cyclone battery cells rated at 2.5Ah per battery. The two ways that have been recommended are welding or solder. The issue I face is if...
  4. bowen44

    RF SWITCH SPST ?

    Thanks for all the info JBE and alva. It helped me to get a better understanding of an RF Switch.
  5. bowen44

    RF SWITCH SPST ?

    The question I had on the rf switch. In a drawing it reads " RF INPUT LEVELS ARE FOR LESS THAN 1 dB COMPRESSION ("ON" CONDITION) and LESS THAN 3 dB DEGRADATION IN ISOLATION ("OFF" CONDITION) AT LEVELS 3 dB BELOW THOSE SHOWN." I am not familiar with the term...
See more

Part and Inventory Search

Back
Top