Thanks a lot JW. Your input was excellent. My problem was fully solved. You made my day. I have been struggling on this for a week & today I found out thit wonderful site.
If I have any further doubts in future I will post it & will need your help again.
Thanks for you help. :-D
I am new to Pro/E. I want to model a circular part in Pro/E. To do so, I am revolving tha sketch about an axis.
The c/sectional sketch (a complex one with lots of lines) of the part has dimensions from 1.0 to 4.0 inches.
I open Pro/E 2001, go to feature->create->solid->protrusion & then select...
