Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by Bolky
-
Pipe Wall Thickness limitation for bend testing
Dear, Regarding ASME IX QW-462.3(a) Gen note (b) : "...if the pipe being tested is equal to or less than NPS 1 (DN 25) pipe size, the width of the bend specimens may be that obtained by cutting the pipe into quarter sections, less an allowance for saw cuts or machine cutting. These...- Bolky
- Thread
- Replies: 0
- Forum: Pipelines, Piping and Fluid Mechanics engineering
