Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by bohornback
-
Relating One Hole pattern to another hole pattern
I have a GD&T question regarding the use of a pattern of features as a datum to locate another pattern of features. Two plates (1 and 2) that are at an angle to one another (about 135 deg lets say). One plate has Datums A,B,C (surface, edge, edge). The other plate has D,E,F (surface, edge ...- bohornback
- Thread
- Replies: 3
- Forum: Drafting Standards, GD&T & Tolerance Analysis
