Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by Bobby4241

  1. Bobby4241

    Stitch edges - mesh update

    Hi All, In the analysis that I`m going, there are intermittent welds. In order to simply, I have "stitch edges" where welds are present and "Unstitch edges" where there are no welds. I also have some 3D geometry as well. I`m making some changes to the 3D geometry in idealized file. When I open...
  2. Bobby4241

    0D Mesh and Mass moment of inertia

    In my analysis, I have a bracket and a valve sitting on the bracket. I have modeled the valve as a 0D mesh at the CG location of the valve. I have supplied only the mass information to the 0D mesh. Ran the analysis and got the results. In the second run, I have supplied the mass moment of...
  3. Bobby4241

    Rename Mesh Mating

    Hi All, Is there a way to name mesh mating before creating it? I see that it takes name automatically which gets difficult to look for a specific mesh mating pair. Renaming mesh mating pairs after creating it is very difficult as it creates close to 7-8 mesh mating pairs when I select 2 bodies...
  4. Bobby4241

    NX Modal analysis results

    How to export the results of modal analysis in NX to an external file? .csv or .txt file.
  5. Bobby4241

    RBE2 elements in NX

    I`m just curious as to why there is a difference in results while using RBE2 elements with Mid node connection and without mid Node connection? I got about 3-4MPa difference during this study. Since RBE2 elements are rigid elements, I was hoping to get same results in both case. Thanks in advance.
See more

Part and Inventory Search

Back
Top