Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by Bobby.T

  1. Bobby.T

    New to GD&T

    2009. You're right about contact happening on the conical surface. This just goes back to my confusion about choosing datums. I keep trying to imagine that there needs to be some physical measurement fixture and wasn't seeing that being very straightforward with the conical surface as datums...
  2. Bobby.T

    New to GD&T

    -ASME Y14.5 -I intend for the cylindrical surfaces to be the datum -Flat head screws will be used
  3. Bobby.T

    New to GD&T

    I'm just starting to get my feet wet with GD&T and I'm hoping to get some general feedback on this print I'm working on. I start to get confused when the datums are anything but planar faces. The part interfaces on datum A and the two countersunk holes. I appreciate any input or...
See more

Part and Inventory Search

Back
Top Bottom