Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations KootK on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by bob16

  1. bob16

    internal pipe thread depth

    Thanks TBP and 74Elsinore. I like the fact that the thread depth is ok from TGP but I also wondered about 8" screwed pipe. We are using ductile iron (dip) in this project so butt welds may not be an option. Or is it? We have layed out two flanged dip reducers to get to the 8&quot...
  2. bob16

    internal pipe thread depth

    Given: Flanged discharge piping in high service potable water plant. Discharge piping is 30" and at 130 psi. Surge valve at end of run is 8". Desire is to install surge valve using 8" piping etc... We can get a 30" blind flange tapped for 8" pipe. Question: Can we...
See more

Part and Inventory Search

Back
Top Bottom