Thanks Sam,
Just to further clarify your responses…
So the older input was poor, thus causing a 30% error? Does that mean poor quality elements introduced into the processor and the results which were generated by the packages own automatic meshing? If it was hand meshed then, I would guess it...
Mr. Borowski,
You wrote above and I quote you...
"I would agree with you on warping and high aspect ratio elements [in Algor]. I don't like hex elements in Algor. I try to avoid using them and try to clean up my models to avoid high-aspect ratios. If it is not possible to do that with your...
Mr. Borowski,
1) I was addressing Sam, an Algor employee, and not you though I appreciate your input here as well. Nice plug for your company and its services, however. I am new to this forum and thought this was prohibited. Also, I would respectfully like to point out that the information you...
Hi Sam,
I am an old Algor customer and am concerned with your comments Sam. I have some follow-up questions for you:
1. Why does the version number matter for an accuracy error of 30%? IMHO 30% is unacceptable. Does this mean that some released versions of Algor are this inaccurate? What...
