Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by Bld-Eng

  1. Bld-Eng

    Modulus of Rupture (MOR) vs Bending Stress (F'b)

    Thank you bugbus Another comment I received from a colleague is that the MOR would be tested on a piece of timber that is clear of defects (like knots, crossgrain etc) that also contributes to the MOR being much higher than the bending stress.
  2. Bld-Eng

    Modulus of Rupture (MOR) vs Bending Stress (F'b)

    Hello, Just hoping for clarity on Modulus of Rupture (MOR) vs. Bending Stress (F'b) as per Australian Codes. I'm looking to hand calculate the bending strength of a 90 x 19mm Merbau decking board with joists 500cts apart. By my calculations, to support a 1.8 kN point load, I need the decking...
See more

Part and Inventory Search

Back
Top