I have a box full of these breakers, not sure how I aquirred them, and they have no identifying marks or labels. They resemble a GE Twin. THe only label is a UL Listing lablel. Can anyone help me identify brand and what panel they will fit?
I have recently taken over the maintenance of a system that has four old Modicon 612 or 512 micro PLC's. I am using ProWorx 32. I have been able to write some changes to the PLC's, but what I can't do is monitor what the logic is doing in run mode. If I could just monitor the status of a few...
You might try ScadaMobile by SweetWilliam Automation. The AB 1400 would have to be on a network with internet access and you can connect directly to the PLC over the internet via IPad or IPhone.
http://www.sweetwilliamsl.com
No I'm not trying to conserve analog inputs. The Micrologix 1100 has two low-resolution 0-10volt analog inputs that I am not using for analog, but I have two of these prox switches in the project and my thoughts were to use these inputs to conserve my digital inputs. I was just looking for a...
eeprom, Attached is wiring diagram for the prox switch I am using. Based on this and your post I would need to wire 24VDC + to IV-Com. and the black from prox to 10k-ohm resistor other end of resistor to IV-1 and 1k-ohm resistor wired between IV-Com. and IV-1. Is this correct...
Supply Voltage Range: 10-48 VDC
Continuous Switching Current: 300 mA
Voltage Drop: <2 VDC
Current Consumption: <10 mA
Switching Frequency: 100 Hz
Power Indicator: Green LED
Signal Indicator: Yellow LED
Overload Protection: Yes
Short Circuit Protection: Yes
Reverse Polarity...
I have a project where I'm using Micrologix 1100 1763-L16AWA controllers. I am also using two capactive type prox switches to detect water level in a tube. These sensors are Gems CAP-100 and they use 6-48vdc power. I would like to use prox sitches on the two embeded 0-10vdc analog inputs on the...
