Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by bjones1

  1. bjones1

    Compressed Air Piping

    Olmedo, I agree - I was making a general statement about how stress is defined in simple terms. However, TBP's reply is more in line with a real life reason for the Sch. 80 pipe being used in this application... Good point TBP...
  2. bjones1

    Compressed Air Piping

    olmedo, In answering your second question about Sch 80 pipe being used on <2&quot; pipe is mainly due to the increased pipe wall stress on small diameter pipes (as well as corrosion, etc.) By definition &quot;stress&quot; is the ratio of Force to Area, i.e. S=F/A - therefore one can see that...
  3. bjones1

    MDT B31.3 Piping &amp; Warmup

    I am not a B31.3 expert, but way I see it; the code applies to &quot;design conditions&quot;, however the design must be able to cover the full operational range of the material selected. The code is not an operational or maintenance code - it is a &quot;design&quot; code. Your design temp as...

Part and Inventory Search

Back
Top