Recent content by binbin93

thank you very much for your cooperation and give me advice. below is our cooler performance for your reference: 1. DP across cooler (gas side): 600Kpa. (inlet = 10000kpa, outlet = 9400kpa), this is not including inlet strainer and strainer is clear. 2. Gas Inlet temperature: 123oC. 3. Gas...

dear ALL, our heater is fouling at gas side and it made by SS316. thanks

thank you very much. yes, we have used N2 back puffing and chemical cleaning also. we use both chemical: acid photphoric and aci sulphamic please advice me these chemical are good for cleaning? thanks binbin

Dear ALL, I'm optimizing our process and try to reduce stablize crude oil temperature from 56oC to 52oC, can you tell me what does RVP effect? and what's RVP and how to calculate it? thank yuo very much binbin

it means Print Circuit Heat Exchanger this use for cooling down gas compressed

Hello, our PCHE cooler is using for cooling down gas temperature with medium cooling water, but it's partially blocked (fouling) to cause cooler low performance. it's indicating DP across high and gas outlet temp high also. please tell me a method to clean cooler thanks binbin93