Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by Bguarino

  1. Bguarino

    Hole to hole distance & inspection, ASME 14.5

    Hi thank you. No, the dimensions are not basic and no datums or GD&T references are present. There are only the two dimensions. If I read between the lines of your statements... without datums & GD&T position tolerance as shown in the sketch it is not clear or implied to measure 2x and 2y?
  2. Bguarino

    Hole to hole distance & inspection, ASME 14.5

    I have a drawing that references ASME 14.5 for interpretation. On this drawing is shown 4 holes that form a "square" shape, and dotted lines connect the 4 holes. There is one dimension for the width and one for the height. How many measurements should an inspector record? The engineer who...
See more

Part and Inventory Search

Back
Top Bottom