Hello,
I will like to model a contact problem, and what I have available is proE and proMechanica Wildfire. I will like to place spring elements in compression between two opposing surfaces. Then apply a moderate load to one of the surfaces and if any spring looses it's compression state then...
Basically I want to model a contact problem. For that purpose I will like to place spring elements in compression between two opposing surfaces. If a moderate load is applied to one of the surfaces, and any spring looses it's compression state then the surfaces are unstable.
Has anyone...
Hello All,
Between two opposing surfaces I will like to place spring elements in compression to test the stability of one surface upon the other (after some load is applied to one surface). I've been studyng proE and proMechanica to see if I can do this using this software. Has anyone tried...
