I think you may be right, I have done sine profiles before and these units resemble the ones I saw there. Our customer may also have slipped in there knowledge of vibration and assumed it was random.
Hi,
I have been given a vibration envelope that I have to test a product based on. I am using a Vibration sofware that I enter a profile for the vibration using Hz and G^2/Hz as the x and y axis. I cannot figure out how to set up the profile as it is given in varying units and I am new to...
Yes I am using Y14.5M-1982
datum A is only the bottom surface as that is the locating face in the assembly
The notes dont really factor into the problem.
Also to clarify the issue I am trying to figure out where to datum for the horizontal positioning of the hole and slot. I feel that tying...
At work I am having to design a L-bracket that will hold a test fixture on a set of rails. The bottom face of the l-bracket locates onto the rail with a slot and that slot should be centered on the part. I am having issues with choosing my datums and if someone could point me in the right...
