Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by ben010

  1. ben010

    Abaqus Standard - Dynamic Implicit - Contact - Scratch/Gouge Damage

    drag step .inp file.http://files.engineering.com/getfile.aspx?folder=b499608d-df2f-48a6-9c94-2246709f0368&file=Job-Drag-100x60bias10.inp
  2. ben010

    Abaqus Standard - Dynamic Implicit - Contact - Scratch/Gouge Damage

    Drag step .cae file.http://files.engineering.com/getfile.aspx?folder=6847020f-9122-4fee-9d31-9882b13e301b&file=8._Job_(drag)(200x150(bias10)).cae
  3. ben010

    Abaqus Standard - Dynamic Implicit - Contact - Scratch/Gouge Damage

    Simplified mesh inp filehttp://files.engineering.com/getfile.aspx?folder=df522f6b-ebd4-4112-8265-cadd733a5fd7&file=Job-Default-2e-03seed.inp
  4. ben010

    Abaqus Standard - Dynamic Implicit - Contact - Scratch/Gouge Damage

    Thanks for the suggestions Robert. I've been working on a model which is in contact at the initial step and has a simple linear mesh as you suggested, see attached. It seems to produce very similar error and warning messages as other model I've been playing around with today. I've also enabled...
  5. ben010

    Abaqus Standard - Dynamic Implicit - Contact - Scratch/Gouge Damage

    .inphttp://files.engineering.com/getfile.aspx?folder=d909d3fd-d04a-4aba-8a96-53cb36a1fdea&file=Job-Cross-Impl.inp
  6. ben010

    Abaqus Standard - Dynamic Implicit - Contact - Scratch/Gouge Damage

    Indentation pichttp://files.engineering.com/getfile.aspx?folder=ed8a210c-9c51-495e-9913-bee3484089cd&file=indentation.jpg
  7. ben010

    Abaqus Standard - Dynamic Implicit - Contact - Scratch/Gouge Damage

    Robert, Thankyou for the response. I've attached the .inp and .cae files which were modelled on Abaqus 6.9-1 and a picture of the mesh density. - Specimen part is 4mm x 1.5mm - Tool is 50 microns tip raduis - Indentation is 25 microns. - Mesh - 200 element (4mm slave surface length)...
  8. ben010

    Abaqus Standard - Dynamic Implicit - Contact - Scratch/Gouge Damage

    Hi all, I've been trying to learn Abaqus and model a slow speed scratching process which replicates an experiment to analyse residual stress. So far I've been able to model the indentation step but cannot seem to drag the tool across the surface to create the scratch. I'm not 100% sure I am...
See more

Part and Inventory Search

Back
Top