here is the diagram.
http://files.engineering.com/getfile.aspx?folder=92922c0b-8a35-463d-b41a-6ead7d92eaa0&file=Diagram.JPG
I'm not structural engineer, but just want to see what is feasible purely based on off the shelf products.
can you open this file ...
Hi @hokie66, if L6 is in one piece across the W4 and W6 and supported by the walls and brick piers, should I look up the table against the span for 2.260 m or 5.08 m ?
Thanks for everyone's responds.
@EngineeringEric
This product is widely used in Australia to support openings in cavity walls. L6 both ends are supported by the load bearing wall and the 350x350mm brick piers.
The ridge beam is 250UB25.7kg.
I'm not a structural engineer (did one subject in...
Hi,
I would like to verify if this product
https://www.onesteelmetalcentre.com/~/media/OneSteel%20Metalcentre/Brochures/Galintel%20T%20Bar%20Brochure.pdf
is capable of supporting roof load and double brick wall based on the product spec.
I've attached a diagram and spreadsheet showing the...
