Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by beaverncsu

  1. beaverncsu

    How to apply pressure parallel to an area on ANSYS

    apply SURF154 element to the area...then apply pressure to the Surf154
  2. beaverncsu

    plastic hinges in a steel beam

    I am not an expert...just try to help. I would prefer using the "stress-true strain" curve (not engineering strain)...if you use Bilinear stress-strain curve..make sure the second slope is not zero. then I will do a hand calculation to figure out about how much load is required when steel about...
See more

Part and Inventory Search

Back
Top Bottom