Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by batman77

  1. batman77

    Manhole Gaskets Standards

    Hello, I'm new to this forum / topic. Can someone guide me to where I can find standard dimensions for oval/obround gaskets. I have this gasket spec and would like to understand what the dimensions are. Spiral wound gasket, KRAJ Type KRS Gasket 465 x 427 / 420 x 382 x 4.5 thickness. THANK you.
  2. batman77

    Chilled Water System Corrossion Protection

    I'm very sorry but I did a typo error. The value is 200microSiemens which means that the conductivity practically remained unchanged after 4 years. It's the pH which went up. sorry again.
  3. batman77

    Chilled Water System Corrossion Protection

    We have a closed loop chilled water system. This system was filled with demineralised water. The main components in the system are: Heat Exchanger Tubes made of copper. Circulating pumps made of cast iron. All pipework made of stainless steel 304. Evaporator at chiller made of copper tubes...
See more

Part and Inventory Search

Back
Top Bottom