Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by bastion
-
Constraints between radial and axial holes
I'm making the transition from MDT6 to Inventor, and I'm having some difficulty with constraints in Inventor. Specifically, I've got a pipe with a radial hole about halfway down its length and a circular flange that fits onto the end of the pipe that has an axial bolt pattern around its...- bastion
- Thread
- Replies: 1
- Forum: Autodesk: Inventor
