Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by banjoray
-
What type gear is right for punching square holes in aluminum angle?
I have a simple need - to punch a 5/16" square hole in 6061-T6 aluminum up to 3/16" thick although 1/8" will be the most common. There are so many options for this I'm sure I'll get the wrong gear if I just go out and buy what the sales guy wants to move. Here are some parameters: * The holes...- banjoray
- Thread
- Replies: 0
- Forum: Commercial product engineering general discussion
