Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by banderas

  1. banderas

    NC 9V LED circuit

    Thanks for your help OperaHouse. This worked. I'll play with resistor values to get brighter LED. Banderas[2thumbsup]
  2. banderas

    NC 9V LED circuit

    skogsgurra, Sorry if my question irritated you,but I tried to build something really simple to indicate when NC switch opens.And I got stuck.I tried pasting my circuit to forum the but it didn't work.I know how to to this with the logic gates but I don't have power available.Thanks for your...
  3. banderas

    NC 9V LED circuit

    I tried to build a simple LED circuit that is going to operate from 9V battery. When NC switch is closed I wouldn't want to draw any current, but this NC switch opens turns on red LED. Circuit I build was heating up the battery. My only requirements are low power consumption (so battery can last...
  4. banderas

    0-5 V signal

    Melone, Hi, with "micro" you mean microprocessor? I thought of that originally, but my budget is limited with stock on hand and probably couple more inexpensive chips. I thought of using 68HC11, but those boards are expensive for my application. And I believe HC11 has intergrated 8...
  5. banderas

    0-5 V signal

    Hi, Sorry for the confusion guys. Let me start all over. I'm building a box that will help me diagnose if my heat exchanger ( here heat exchanger beeing a support equipment for some other tool) communicates with the main tool, before I install it. I'm trying to build a box that will send...
  6. banderas

    0-5 V signal

    Hi, thanks for replaying to this question. I have already used 7805 to step down voltage from my regulated DC power supply (+-15 V)to 5V and potentiometer in series to change output voltage.I can control temperature by adjusting potentiometer( I believe 40 mV is one C).I'm trying to find some...
  7. banderas

    0-5 V signal

    Hi, I'm trying to build a box that will simulate 0-5V signal.I'm using this signal as a remote temperature set point for a heat exchanger. I have already tried it using DC power supply and potentiometer in series and it works. Now I'm wondering if there is a driver chip that will do same?Thanks
See more

Part and Inventory Search

Back
Top