Eng-Tips is the largest forum for Engineering Professionals on the Internet.

Members share and learn making Eng-Tips Forums the best source of engineering information on the Internet!

Register Log in
  • Congratulations dmapguru on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by Auxcron1

  1. Auxcron1

    Reference Point System

    Thanks a lot everyone, Garland23 and Ryan6338 I used position tolerance for that very reason, I need to control their relative position as well which to my understanding, perpendicularity alone with CZ can't do. I always avoided using orientation control with CZ to control relative position as...
  2. Auxcron1

    Reference Point System

    Germermaman thanks a lot for your reply. I think CZ for datum feature C is still important as if the CZ was not there, bot surfaces would be treated independently. The position control as it is used in the picture is only controlling the orientation of the datum feature C, even though it is a...
  3. Auxcron1

    Reference Point System

    Hi everyone, I would like to ask a question about creating a datum reference system. Me an my colleague were discussing whether the below is an appropriate GD&T notation. There are two 0-point pockets that are used to construct reference point system. It is part of a larger jig. Picture shown...
See more

Part and Inventory Search

Back
Top