The sidewalls of the tab at its base (including fillets) define the position (left/right) of the tab in the mating feature (see image below). The hole engages with a snap but that snap does not dictate left/right position of the tab.
I'm struggling in understanding how to implement this. I...
Thanks everyone for your responses. I've added an image to show everyone a bit more detail what I'm hoping to check. I need to make sure that the tab needs fits into the slot and there are 18 of these tabs of varying widths (31.9mm dimension in my example - Option 2). I've included what I...
I have a part that contains a number of tabs with slots around the perimeter of the part.
I would like to verify the position and width at the base of each slot. The challenge that I'm struggling to address is that the width at the base (red box) differs slightly for each slot. I'd like to...
