Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by AttilaK
-
MAWP and Safety Valve Set Pressure
Thank you for the reply. I'll try to explain better. I need to have design pressure at 2.5 bar and so the MOWP will be at least 2.5 bar. Then I need to set the pressure of the safety valve at not more than 1 bar to restrict the maximum operating pressure. Is it possible? My concerning is that...- AttilaK
- Post #3
- Forum: Boiler and Pressure Vessel engineering
-
MAWP and Safety Valve Set Pressure
Hi all, I have a strange question about pressure vessel designing in ASME code. Is it possible to have a design pressure of 2.5 bar and a safety valve set to 1 bar ? After the calculation of the components, I will have the MAWP of the completed vessel that must be equal or higher than the...- AttilaK
- Thread
- Replies: 7
- Forum: Boiler and Pressure Vessel engineering
