Recent content by atn57

does any run the TMG in IDEAS?

feadude, Is this possible to do this with mapped meshing? Thanks for the great info........... again thanks ant...

I wanted to know if i can surface mesh an volume then go back and do a volume mesh...........with the same element size and number????//

Does anyone know how to volume mesh a part.? thanks tony

Does anyone use the tmg and translation to SINDA? I am translating a model to SINDA but I am getting -1 for the capacitances and I have put the material props. I am not sure why I am getting -1 thanks tony

an exact visulization of the honeycomb thanks

does anyone know how to create honeycombs in catia thanks tony

does anyone know how to create honeycombs in catia. thanks tony

Hello everyone. I wanted to know if there was a way to generate honeycombs behind a door. thanks tony

kevin, wow....thanks.........................construction points and not standard.......ones... thanks tony

kevin, wow....thanks.........................construction points and not standard.......ones... thanks tony

I am getting the error the selected sketch contains several open profiles or some geometry used for contruction. You must specify the construction geometry to solve the profile ambiguity. do you want to use the selected sketch anyway

I have drawn a wire frame and I wanted to know how to make all the lines continuous...so they all connect and i can either pad or extrude them.. help lines tony

Ashvanth Viswanathan, Thanks for the info. but it seems it a bit more confusing to smooth the curves out. But I will continue to try to smooth them out. Thanks for the help. thanks tony

Hello all, I wanted to know how come I am getting hump on the surface when I am tryin to fill. thanks tony