Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by asdjk

  1. asdjk

    Purely plastic analysis

    Hi guys, I'm trying to proceed a fully plastic analysis (without elastic behavior) of a plate under axial load. In order to do a fully plastic analysis, I adopted a very high Young's modulus (i.e. 10^10 MPa, because it's not possible to remove the elastic part) and run a general static step...
  2. asdjk

    Riks Analysis - Inversion on lateral displacement curve / bounced back

    Hi guys, I'm using Abaqus v14 to model a thin plate (4mm) under in-plane loads (axial loads) that has a high Elastic Modulus (E = 10^7 MPa) in order to get a plastic behavior (disregard the initial elastic deformation). The load-displacement curve (axial load VS out of plane displacement)...
  3. asdjk

    Riks - Load-displacement curve bounced back, invert to negative

    Hi guys, I'm modelling a thin plate (4mm) under in-plane loads (axial loads) that has a high Elastic Modulus (E = 10^7 MPa) in order to get a plastic behavior (disregard the initial elastic deformation). The load-displacement curve (axial load VS out of plane displacement) starts loose axial...
  4. asdjk

    No stop script code - Even with no convergence results

    Thanks zwtipp05. But it seems that (in my case) there is no clear "Python Error" but an Abaqus Error. In CMD, the following message appears: "Abaqus Error: Abaqus/Standard Analysis exited with an error - Please see the message file for possible error messages if the file exists...
  5. asdjk

    No stop script code - Even with no convergence results

    Hi guys, I wrote a Python script code to proceed a parametric plastic analysis in Abaqus. Inside the loop, I added these below lines: mdb.jobs[job_name].submit(consistencyChecking=OFF) mdb.jobs[job_name].waitForCompletion() Unfortunately, some models do not converge and the whole script (that...
See more

Part and Inventory Search

Back
Top