Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by asdad
-
Failure mode during manufacturing of Neo magnet
If the material is properly aligned, the BH curve should look like a square (not a curve). Since the Hc and Hcj values are close it can be assumed that the material is aligned but you need to look at the actual BH curve to be sure. Low power usually means low BR value. Check your vendor`s...- asdad
- Post #8
- Forum: Magnetic engineering
