Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by Arvii

  1. Arvii

    NX Post processor NC output Problem

    Hi Franklin, Can you please tell me how can I change the radius into no_modal?
  2. Arvii

    NX Post processor NC output Problem

    Hi everyone, I have made my own post-processor in NX 12.0 for Siemens_840D Control. I faced a little bit of a problem in NC output. can you guys have some solution? as you can see in this program some arc didn't have CR=. N1 G54 G17 G90 G64 N2 G0 Z8. N3 M6 T0 N4 S0000 M3 N5 X.3125 Y.2499 Z.5...

Part and Inventory Search

Back
Top