Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by ArijitME

  1. A

    Abaqus help

    Thank you so much. It works now by unchecking the box for adjust at tie constant dialog box. I am actually simulation 2 layer additive manufacturing model in Abaqus. For single pass at each layer it works with tie constraint and does not through similar error. But these error occurs when I...
  2. A

    Abaqus FEA analyses problem

    I am having following error in additive manufacturing modeling in abaqus. I am getting the following error: Error in job 2LayersAM: The volume of 256 elements is zero, small, or negative. Check coordinates or node numbering, or modify the mesh seed. In the case of a tetrahedron this error may...
  3. A

    Abaqus help

    I am having following error in additive manufacturing modeling in abaqus. I am getting the following error. Error in job 2LayersAM: The volume of 256 elements is zero, small, or negative. Check coordinates or node numbering, or modify the mesh seed. In the case of a tetrahedron this error may...
See more

Part and Inventory Search

Back
Top